News:

SMF - Just Installed!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Artie1085

#1
I did a build with a 10 gal metal trash can attached to an old sears vacuum. Small hose and pvc fittings not even glued in place just force fit. Some times if there is a lot of chips from my Rigid 4510 I get some blowby from the side of the blade enclosure but it falls to the floor under the saw. My top is amde of 3/4 mdf with a groove 1/2 in  from the edge to fit the ca and self stick weatherstrip in the groove. Top is held down by a bungee cord attached to the handles. Almost no deporit in the vacuum fikter bag and no leaks. Baffle is 1/8 in hardboard which I miscut to 270 degrees instead of 240. Doesn't seem to have affected performance.