J. Phil Thien's Projects

Hello I have made ​​a new top hat thien separator, here are the details of the project

- diameter inlet dirty air and outlet air 100mm
- slot 25mm
- diameter recycled bin 500mm

some photo in attach.

ok where can I see some examples?
I could do it later to improve filtration though I realize that is not enough.

greetings

Ok so I realized that I have to increase the diameter of the collection bucket and change the input part of the dirty air.
So I will 500mm diameter, height 200mm, inlet and outlet pipes from 100mm.
I start to draw the new filter, greetings

At this point I have to change the diameter of the bucket and go from 300 to 500mm in this way the inlet tube would be 100mm away from the outlet, is correct?

hi I'm costruento this thien separator and my suction pipe is 100mm, while the dirt container is 300mm.
So I sized the top hat thien separator in this way:
- Dirty air inlet pipe 100mm
- Clean air outlet pipe 100mm
- Slot capture dust 25mm x 240 °
- Height of 100mm top hat

Can you tell me if I did well?
I attach some photos