Hi Everyone
This is my first post. I've spent a lot of time lurking and reading. I'm going to build my first baffle to be used with a metal trash can on a Delta 50-760.
I've plumbed my shop with 5" snaplock pipe so my baffle will also utilize 5" connections. I really like the side inlet designs and I'm leaning towards that. Some questions:
1) I'm assuming that in order to entry the can the side inlet needs to be disconnected.....anyone find a good quick disconnect?
2) Since I'll have the available real estate in the top, can i use the trash can lid itself? I've found 5" flanges so all I think I need to do is cut a 5" hole in the lid, rivet the flange in place and seal it with some silicone. Any reason not to use the metal trash can lid?
Thank you. This has really been a very helpful forum
Regards
George
This is my first post. I've spent a lot of time lurking and reading. I'm going to build my first baffle to be used with a metal trash can on a Delta 50-760.
I've plumbed my shop with 5" snaplock pipe so my baffle will also utilize 5" connections. I really like the side inlet designs and I'm leaning towards that. Some questions:
1) I'm assuming that in order to entry the can the side inlet needs to be disconnected.....anyone find a good quick disconnect?
2) Since I'll have the available real estate in the top, can i use the trash can lid itself? I've found 5" flanges so all I think I need to do is cut a 5" hole in the lid, rivet the flange in place and seal it with some silicone. Any reason not to use the metal trash can lid?
Thank you. This has really been a very helpful forum
Regards
George