News:

SMF - Just Installed!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - polarys425

#1
That's what i thought it might be. So, somehow a $400 DC that needs almost as many mods as the HF is somehow better because it costs more? I don't get it.  The only components that one could maybe argue is better is the motor & impeller. In todays make it cheaper manufacturing that may or may not be the case. Plenty of these HF DC motors have lived long lives.  Otherwise you have a DC that still needs a separator, a better filter, a larger intake (to collect fines), etc. You've already spent more just for your DC than i paid for my DC, the impeller, my separator (free-cycled material), and my 6" S&D piping.

The HF DC is a long time recognized diamond in the rough. Not everything HF sells is junk. Would i buy most of the stuff they sell? No. But as with anything else, prudent shopping at HF can save some serious coin on items that the chinese copy and sell at ridiculously low prices under generic names. (bar clamps, diamond sharpeners, drill chucks, some of the HVLP guns rival those costing much more, air hose (goodyear brand), air nozzles, air fittings, hose reels, and quite a bit more.)

It's not my intention to pick a battle or anything, i just don't see anything about the Delta unit that justifies $400, and i think you've written off the HF unit based solely on its price. Price can be an indicator of quality, however, there are products that are severely overpriced. DC's are just that, overpriced. So, one being sold at a reasonable price doesn't necessarily make it junk. Truth be known, the HF and Delta units probably have very similar costs of manufacturing.
#2
Which model is that?
#3
So, you'd buy the Rikon machine for $399 instead? The two machines are nearly identical, other than the 12" impeller vs. the 10" or so on the HF. The HF machine can be had for $150 or so. Add $80 for the 12" impeller, and $230 or so is still way cheaper for the same equipment. Top hat separators are cheap to make, so on a small budget, one can have a machine that rivals much more expensive equipment.
#4
I can't speak for the Grizzly impeller, but i know for a fact that the 12" Rikon impeller fits my HF DC perfectly. The vanes of the impeller curved in the opposite direction, but i have increased airflow, and decreased noise. The Rikon impeller is about $60 + $20 shipping.
#5
I used MDF for mine as well since i had some. I did all my cutting and routing outside.....
#6
I've read conflicting information on this......

I made a new 6" takeoff for the impeller housing for mine, and kept the original 5" opening plate intact. I couldn't find 5" pipe when i did my ductwork.

I'll have to test it sometime.....
#7
Thanks, I only wish i'd been aware of the "shorts" when i ordered my filter from them. I'm making do right now with a regular piece of 6" metal pipe, and propping the can on a couple pieces of 2x4. That way i can drop the can down and get it out.
#8
Where can i get a 1-2ft or so section of 6" flex? Everything i found so far is 10' lenths or more. I need to make the connection from the impeller housing to the output of the tophat separator.

Thanks in advance


Kevin
#9
If i had a way to measure the CFM's i could tell ya.....