What is "1 D" bend?
- Welcome to J. Phil Thien's Projects.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Thien Cyclone Separator Lid Discussion / Re: Modifying a Jet 1100 DC with the Thien Baffle for a Wynn Filter
September 16, 2011, 08:16:46 AM
Would 3" be too much?
#3
Thien Cyclone Separator Lid Discussion / Re: Modifying a Jet 1100 DC with the Thien Baffle for a Wynn Filter
September 15, 2011, 01:18:49 PM
I'm planning on using Paul's design above. Would it benefit from having a tube going up into the filter above the baffle instaed of just the opening shown?
#4
Thien Cyclone Separator Lid Discussion / Locating Baffle Mounting Holes
September 13, 2011, 07:50:30 PM
In this thread, http://www.jpthien.com/smf/index.php?topic=100.msg500#msg500, Paul describes what I'd like to do, but I can't figure out hole to locate the holes in the DC ( the ones that mount the dowels to the DC).
See 4th picture down.
Also, has anyone washed the Jet 1100 cannister with a garden hose and dried it successfully?
Thanks
See 4th picture down.
Also, has anyone washed the Jet 1100 cannister with a garden hose and dried it successfully?
Thanks
Pages1