No empty body either... :o :o
- Welcome to J. Phil Thien's Projects.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Thien Cyclone Separator Lid Discussion / Re: Too much dust getting through to the collector
May 14, 2021, 09:39:02 AM #2
Thien Cyclone Separator Lid Discussion / Re: Too much dust getting through to the collector
May 14, 2021, 09:38:11 AM
I can only upload 1 picture at a time due to size.
#3
Thien Cyclone Separator Lid Discussion / Too much dust getting through to the collector
May 14, 2021, 09:37:19 AM
Hello everyone that hears me!!
I have a situation that needs addressing. I am hoping to make continual tweaks until I get this thing dialed in. My first change was lowering the baffle 1 1/2". I originally had it adjusted to about 1/2" below the 45 degree inlet. My next thought is to adjust the angle in which that inlet is currently set. I would love to hear some feedback of what I am doing wrong. I will post more pictures or take more measurements to work through.
Thanks ahead of time for your time....
Nate
I have a situation that needs addressing. I am hoping to make continual tweaks until I get this thing dialed in. My first change was lowering the baffle 1 1/2". I originally had it adjusted to about 1/2" below the 45 degree inlet. My next thought is to adjust the angle in which that inlet is currently set. I would love to hear some feedback of what I am doing wrong. I will post more pictures or take more measurements to work through.
Thanks ahead of time for your time....
Nate
Pages1